Common Name: 2-Bromo-4′-Chloropropiophenone
CAS Number :877-37-2 Molecular Weight: 247.51600
Density: 1.518g/cm3 Boiling Point :296.7ºC at 760 mmHg
Molecular Formula: C9H8BrClO Melting Point :N/A
MSDS :N/A Flash Point: 133.2ºC

Density :1.518g/cm3
Boiling Point :296.7ºC at 760 mmHg
Molecular Formula :C9H8BrClO
Molecular Weight :247.51600
Flash Point :133.2ºC
Exact Mass: 245.94500
PSA :17.07000
LogP: 3.30610
Index of Refraction :1.57


Material Safety Data Sheet
Section1. Identification of the substance

Product Name: 2-Bromo-1-(4-chlorophenyl)propan-1-one
Section2. Hazards identification

Harmful by inhalation, in contact with skin, and if swallowed.
Section3. Composition/information on ingredients.

Ingredient name:2-Bromo-1-(4-chlorophenyl)propan-1-one
CAS number:877-37-2
Section4. First aid measures

Skin contact:Immediately wash skin with copious amounts of water for at least 15 minutes while removing
contaminated clothing and shoes. If irritation persists, seek medical attention.
Eye contact:Immediately wash skin with copious amounts of water for at least 15 minutes. Assure adequate
flushing of the eyes by separating the eyelids with fingers. If irritation persists, seek medical
Inhalation:Remove to fresh air. In severe cases or if symptoms persist, seek medical attention.
Ingestion:Wash out mouth with copious amounts of water for at least 15 minutes. Seek medical attention.
Section5. Fire fighting measures

In the event of a fire involving this material, alone or in combination with other materials, use dry
powder or carbon dioxide extinguishers. Protective clothing and self-contained breathing apparatus
should be worn.
Section6. Accidental release measures

Personal precautions: Wear suitable personal protective equipment which performs satisfactorily and meets local/state/national
Respiratory precaution:Wear approved mask/respirator
Hand precaution:Wear suitable gloves/gauntlets
Skin protection:Wear suitable protective clothing
Eye protection:Wear suitable eye protection
Methods for cleaning up: Mix with sand or similar inert absorbent material, sweep up and keep in a tightly closed container
for disposal. See section 12.
Environmental precautions: Do not allow material to enter drains or water courses.
Section7. Handling and storage

Handling:This product should be handled only by, or under the close supervision of, those properly qualified
in the handling and use of potentially hazardous chemicals, who should take into account the fire,
health and chemical hazard data given on this sheet.
Store in closed vessels, refrigerated.
Section8. Exposure Controls / Personal protection

Engineering Controls: Use only in a chemical fume hood.
Personal protective equipment: Wear laboratory clothing, chemical-resistant gloves and safety goggles.
General hydiene measures: Wash thoroughly after handling. Wash contaminated clothing before reuse.
Section9. Physical and chemical properties

Appearance:Not specified
Boiling point:No data
No data
Melting point:
Flash point:No data
Density:No data
Molecular formula:C9H8BrClO
Molecular weight:247.5
Section10. Stability and reactivity

Conditions to avoid: Heat, flames and sparks.
Materials to avoid: Oxidizing agents.
Possible hazardous combustion products: Carbon monoxide, hydrogen chloride, hydrogen bromide.
Section11. Toxicological information

No data.
Section12. Ecological information

No data.
Section13. Disposal consideration

Arrange disposal as special waste, by licensed disposal company, in consultation with local waste
disposal authority, in accordance with national and regional regulations.
Section14. Transportation information

Non-harzardous for air and ground transportation.
Section15. Regulatory information

No chemicals in this material are subject to the reporting requirements of SARA Title III, Section
302, or have known CAS numbers that exceed the threshold reporting levels established by SARA
Title III, Section 313..



Post time: Jul-22-2022